How to Set Up or Configure VPN (Virtual Private Network) in Windows 7

Virtual Private Network in short VPN is a technology which lets a computer using a public Internet connection to join a private network by way of a secure “tunnel” between that machine and the network. One of the most common case is a company allowing its employees to connect their work networks from home or […]

7 steps in Configuring Source Based Routing in Juniper Networks

Recently we have posted a tutorial on How to Configure Source Based Routing and Source Interface Based Routing. Now we collected step by step procedure to configure Source Based Routing in Juniper Networks via WebUI or CLI. To configure a source-based route, perform the following steps via the WebUI or CLI: To Configure Source Based […]

Juniper Network Connect Client Download

The Juniper Networks Network Connect is a software package from Juniper Networks that interfaces with its Secure Access hardware and provides a Virtual Private Network (VPN) solution. The Network Connect (NC) provides a clientless VPN user experience, serving as an additional remote access mechanism to corporate resources using an IVEĀ  appliance. This feature supports all […]

Download Juniper Client installer from an SA Series device (Installing Juniper Setup Client)

This post helps on How to download the Juniper Setup Client installer from an SA Series device and run the installation locally as a standalone application. The following information helps you to download the Juniper setup Client and install it locally. When a user signs in to the SA series device for the first time […]

How to check all disabled interfaces at a time in Juniper console

When you have Juniper EX4500 switch with JunOS 11.4R1.6 and has 96 interfaces in total. Due to some tests which might involve in repeated enabling and disabling interfaces in different configurations can some times end up in some havoc. If you want to make sure whether you forgot to enable them or left them in […]

Juniper Load balancing in firewalls between SSG 20 and ADSL

In order to balance the load in juniper firewalls between SSG 20 and ADSL one can force one network say network A on trust to pass through ISP 1 with metric 1 and through ISP2 with metric 2 for fail over. Next the other network B on DMZ to pass through ISP 2 with metric […]

How to Configure Source Based Routing and Source Interface Based Routing

How to configure source-based and source interface based routing in Juniper networks is a burning question for many Juniper Clients so I collected a small tutorial from Junipers website and presented here. After adding source based and source interface based routes we need make sure that we have enabled source based or source interface based […]